|
|
|
|
|
questionable |
March 3, 2014 |
Reviewer:
Hardintheink…EmEl from west chester, PA United States
|
|
Firstly I was trying to build a color packer machine .....the tops of the coil bobbins had plastic encased around it to point where the a-bar wasn't sitting flat same with the back and when it did come the back coil was grinded and shaved down in an or way I was mounting then onto a standard 32mm walker frame 8/32 also and had a hard time with every other standard short 8\32 screws I had and used oil all failed to really go in correctly becuz the thread was bored and taped all weird and had too much left over material biting into my screw threads had to forceeem then when trying to care fully mmanuver the wires around the frame to mount one of the rear post wires broke and I had to re flux an solder that bitch again damn that was stupid and I can build a machine well too many adjustments
Was this review helpful to you?
|
|
|
|
|
|